/run/particle/

Commands for G4VUserPhysicsList.

Sub-directories :

Commands :

verbose [level]

Set the Verbose level of G4VUserPhysicsList.
0 : Silent (default)
1 : Display warning messages
2 : Display more

Range : level >=0 && level <=3

Available at all Geant4 states.

Parameters

level

type i

Omittable : default value = 0

setCut [cut] [Unit]

Set default cut value
This command is equivallent to /run/setCut command.
This command is kept for backward compatibility.

Range : cut >0.0

Available Geant4 state(s) : PreInit Idle

Parameters

cut	type d
Unit	type s	Omittable : default value = mm	Parameter candidates : pc km m cm mm mum nm Ang fm parsec kilometer meter centimeter millimeter micrometer nanometer angstrom fermi

dumpList

Dump List of particles in G4VUserPhysicsList.

Available at all Geant4 states.

addProcManager [particleType]

add process manager to specified particle type

Available Geant4 state(s) : Init Idle GeomClosed EventProc

Parameters

particleType

type s

Omittable : default value =

buildPhysicsTable [particleType]

build physics table of specified particle type

Available Geant4 state(s) : Init Idle GeomClosed EventProc

Parameters

particleType

type s

Omittable : default value =

storePhysicsTable [dirName]

Store Physics Table
Enter directory name

Available Geant4 state(s) : Idle

Parameters

dirName

type s

Omittable : default value =

retrievePhysicsTable [dirName]

Retrieve Physics Table
Enter directory name or OFF to switch off

Available Geant4 state(s) : PreInit Idle

Parameters

dirName

type s

Omittable : default value =

setStoredInAscii [ascii]

Switch on/off ascii mode in store/retreive Physics Table
Enter 0(binary) or 1(ascii)

Range : ascii ==0 || ascii ==1

Available Geant4 state(s) : PreInit Idle

Parameters

ascii

type i

Omittable : default value = 0

applyCuts [Flag] [Particle]

Set applyCuts flag for a particle.
Some EM processes which do not have infrared divergence
may generate gamma, e- and/or e+ with kinetic energies
below the production threshold. By setting this flag,
such secondaries below threshold are eliminated and
kinetic energies of such secondaries are accumulated
to the energy deposition of their mother.
Note that 'applyCuts' makes sense only for gamma,
e- and e+. If this command is issued for other particle,
a warning message is displayed and the command is
ignored.
If particle name is 'all', this command affects on
gamma, e- and e+.

Available Geant4 state(s) : PreInit Init Idle

Parameters

Flag	type s	Omittable : default value = true
Particle	type s	Omittable : default value = all

dumpCutValues [particle]

Dump a list of production threshold values in range and energy
for all registered material-cuts-couples.
Dumping a list takes place when you issue 'beamOn' and
actual conversion tables from range to energy are available.
If you want a list 'immediately', use '/run/dumpRegion' for threshold
list given in gange only. Also, '/run/dumpCouples' gives you the
current list if you have already issued 'run/beamOn' at least once.

Available Geant4 state(s) : PreInit Idle

Parameters

particle

type s

Omittable : default value = all